Ultra-tec® stainless steel cable railing systems

Mounting holes and boring diagrams for cable railing

This page provides links to Boring Guides and Mounting information. Our goal is to help the design professional save time and avoid costly mistakes in designing a beautiful cable railing out of metal.

Swageless fittings - No swaging required

Use on non-tensioning end.
Push-Lock™ and Pull-Lock™ Stop End Fittings .pdf

Device that requires no exact measuring.
Push-Lock™ and Pull-Lock™ Stop End Fittings .pdf

Tensions with Allen wrench.
Recever with Push-Lock™ Stud .pdf

Tensioning devices - Require swaging

Can be concealed inside metal or wood post.
Invisiware® Receiver .pdf

Screws into drilled/tapped hole in metal post.
Adjust-a-Body® with Threaded Bolt Tensioner .pdf

Use on straight run or stairs.
Adjust-a-Jaw® Tensioner .pdf

Use on straight run or stairs.
Adjust-a-Body® with Threaded Eye Tensioner .pdf

Non-tensioning (stop-end) fittings

Can be concealed inside metal or wood post.
Invisiware® Radius Ferrule .pdf

Use on straight run or stairs.
Ultra-tec® Fixed Jaw .pdf

Invisiware® Swaging Stud .pdf

Ultra-tec® Clip-on-Stop .pdf

Mounting aids

Invisiware® Extended Tab
Invisiware® Threaded tabs.pdf

Invisiware® Threaded Tab
Invisiware® Threaded tabs.pdf

Weld into post to mount jaw or eye type fitting
Invisiware® Fixed Tab .pdf

Weld into post to accept Invisiware® Threaded Stud
Invisiware® Welded Receivers .pdf

Boring and slotting where grommets are being used
Grommets .pdf

• 
  Intermediate Posts & Cable Braces
• 
  Tubed Corner Sections / Specs.
• 
  Frames for Vertical Cables